Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for Sedan)

BRAKE MASTER CYLINDER (for Sedan) > DISASSEMBLY



1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY


C116942
  1. Fix the brake master cylinder sub-assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a pin punch and a hammer, tap out the brake master cylinder straight pin.

  1. Remove the brake master cylinder reservoir sub-assembly and the 2 grommets.

  1. Remove the brake master cylinder reservoir filler cap and the brake master cylinder reservoir strainer from the brake master cylinder reservoir sub-assembly.



2. REMOVE BRAKE MASTER CYLINDER KIT


C121686
  1. Push in the piston and remove the snap ring using snap ring pliers.



    C121687
  1. Push in the piston and remove the piston stopper bolt and the gasket.

  1. Remove the No. 1 piston sub-assembly from the master cylinder body by pulling it straight out.

    NOTICE:
    Do not scratch the inside of the master cylinder body.



    C053481
  1. Tap the flanged part against wooden blocks until the end of the No. 2 piston sub-assembly comes out. When the end of the No. 2 piston sub-assembly comes out, pull the No. 2 piston sub-assembly straight out of the master cylinder body.

    NOTICE:
    Do not scratch the inside of the master cylinder body.