Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for Sedan)

BRAKE MASTER CYLINDER (for Sedan) > REASSEMBLY



1. INSTALL BRAKE MASTER CYLINDER KIT
  1. Fix the master cylinder body in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.



    C121834E02
  1. Apply lithium soap base glycol grease to the rubber part as shown in the illustration.
    Text in Illustration 
    *1
    No. 1 Piston Sub-assembly
    *2
    No. 2 Piston Sub-assembly
    V100135
    Lithium Soap Base Glycol Grease

  1. Install the No. 1 piston sub-assembly and the No. 2 piston sub-assembly to the master cylinder body.

    NOTICE:
    1. Install the No. 1 piston sub-assembly and the No. 2 piston sub-assembly straight while being careful not to damage the inside of the master cylinder body.
    2. Do not damage the lip of the cylinder cup.



    C121687
  1. Push in the piston and install a new gasket and a new piston stopper bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



    C121686
  1. Install the snap ring using snap ring pliers with the piston pushed in.

    NOTICE:
    Do not scratch the inside of the master cylinder body.



2. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Install the brake master cylinder reservoir strainer and the brake master cylinder reservoir filler cap to the master cylinder reservoir sub-assembly.

  1. Apply lithium soap base glycol grease to 2 new grommets and install them to the master cylinder body.

  1. Install the master cylinder reservoir sub-assembly to the master cylinder body.



    C116942
  1. Using a pin punch and a hammer, tap in the brake master cylinder straight pin.