Home › Brake › BRAKE SYSTEM (OTHER) › PROPORTIONING VALVE (for Hatchback)

PROPORTIONING VALVE (for Hatchback) > REMOVAL



1. REMOVE CENTER COWL TOP VENTILATOR LOUVER


C241431
  1. Disengage the 2 clips and slide the hood to cowl top seal as shown in the illustration.



    C241408
  1. Disengage the 2 claws and separate the washer hose joint.

    NOTICE:
    To prevent washer fluid from contaminating the brake master cylinder reservoir, do not separate the washer hose.

  1. Disengage the 2 claws and 6 guides remove the cowl top ventilator louver center.



2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE BATTERY


    A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



4. REMOVE BATTERY TRAY


5. REMOVE BATTERY CARRIER


    A259809
  1. Disengage the 6 clamps and disconnect the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



6. REMOVE PROPORTIONING VALVE


    C244473
  1. Using a union nut wrench 10 mm, separate the 6 brake tubes from the proportioning valve and the brake tube way.



    C244474
  1. Remove the 2 bolts and the proportioning valve bracket.



    C244475
  1. Using a union nut wrench 10 mm, remove the 3 brake tubes from the proportioning valve and the brake tube way.



    C244476
  1. Remove the 2 nuts and the proportioning valve from the proportioning valve bracket.