DTC U0129 Lost Communication with Skid Control ECU |
| DTC No. | DTC Detecting Conditions | Trouble Areas |
| U0129 | When either of following conditions detected:
|
|

| 1.CONFIRM DTC OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Combination Meter / Trouble Codes.
Start the engine and wait for at least 60 seconds.
Check for DTCs.
| Result | Proceed to |
| DTC output | A |
| DTC not output | B |
|
| ||||
| A | ||
| ||