Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH (for Hatchback)

CLUTCH SWITCH (for Hatchback) > INSTALLATION


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL NO. 2 CLUTCH START SWITCH ASSEMBLY
  1. Fully loosen the lock nut of the No. 2 clutch start switch assembly.

  1. Adjust the No. 2 clutch start switch assembly until the center of the clutch pedal pad is at the standard height (Click here ).

  1. Tighten the lock nut and ensure that the threaded portion is in contact with the cushion.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Connect the connector.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
  1. Engage the 5 claws and 2 clips and install the instrument panel finish panel.



4. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
  1. Engage the 2 claws and 5 clips and install the instrument panel finish panel.



5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Engage the guide and the claw.

  1. Install the instrument panel under cover with the 2 <A> screws.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSPECT SRS WARNING LIGHT (w/ Knee Airbag)
(Click here)