Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH (for Hatchback)

CLUTCH SWITCH (for Hatchback) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



4. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


    B284273
  1. Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


    B284274
  1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


7. REMOVE NO. 2 CLUTCH START SWITCH ASSEMBLY


    C241410
  1. Disconnect the connector.

  1. Loosen the nut and remove the No. 2 clutch start switch assembly.