Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK (for Hatchback)

REAR DOOR LOCK (for Hatchback) > INSPECTION



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    B228541E11
  1. Check the operation of the door lock motor.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear Door Lock Assembly LH)
    *b
    UNLOCK
    *c
    LOCK

    1. Apply battery voltage and check the operation of the rear door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Locked
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlocked

      If the result is not as specified, replace the rear door lock assembly LH.



    B228541E12
  1. w/ Unlock Detection Switch:
    Check the resistance of the unlock detection switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear Door Lock Assembly LH)
    *b
    UNLOCK
    *c
    LOCK

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      Unlocked
      Below 1 Ω

      If the result is not as specified, replace the rear door lock assembly LH.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    B228542E11
  1. Check the operation of the rear door lock motor.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear Door Lock Assembly RH)
    *b
    LOCK
    *c
    UNLOCK

    1. Apply battery voltage and check the operation of the rear door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Locked
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlocked

      If the result is not as specified, replace the rear door lock assembly RH.



    B228542E12
  1. w/ Unlock Detection Switch:
    Check the operation of the unlock detection switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear Door Lock Assembly RH)
    *b
    LOCK
    *c
    UNLOCK

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlocked
      Below 1 Ω

      If the result is not as specified, replace the rear door lock assembly RH.