THEFT DETERRENT SYSTEM (for Hatchback) > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hood Courtesy Switch | Engine hood courtesy switch / OFF or ON | OFF: Engine hood open ON: Engine hood closed | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) - BODY GROUND) |
Disconnect the A63 engine hood courtesy switch (hood lock assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A63-1 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) - MAIN BODY ECU) |
Disconnect the D144 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A63-2 (+) - D144-5 (HCTY) | Always | Below 1 Ω |
| A63-2 (+) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) |
Inspect the engine hood courtesy switch (hood lock assembly) (Click here).
|
| ||||
| OK | ||
| ||