METER / GAUGE SYSTEM (for Hatchback) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / DTC.
Check DTCs and then write them down.
Confirm the details of the DTCs.
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (do not start the engine).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / DTC / Clear.
Clear DTCs by pressing the YES button on the tester.