Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM (for Sedan)

METER / GAUGE SYSTEM (for Sedan) > DTC CHECK / CLEAR



DTC CHECK
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream ON.

  4. Enter the following menu items: Body Electrical / (desired system) / Trouble Codes.

  5. Check the DTC(s) and freeze frame data, and then write them down.

  6. Click here to check the details of the DTC(s).


CLEAR DTC (Using a Techstream)
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the tester ON.

  4. Enter the following menu items: Body Electrical / (desired system) / Trouble Codes.

  5. Press the YES button to clear the DTC(s).


CLEAR THE DTC (Without using a Techstream)
  1. Perform either one of the following operations.

    1. Disconnect the negative battery cable for more than 1 minute.

    2. Remove the ECU-B fuse from the engine room relay block located inside the engine compartment for more than 1 minute.