UPPER INSTRUMENT PANEL (for Hatchback) > REASSEMBLY |
| 1. INSTALL NO. 5 INSTRUMENT PANEL CUSHION |
![]() |
Install a new instrument panel cushion as shown in the illustration.
| 2. INSTALL INSTRUMENT PANEL CUSHION (for TMC Made) |
![]() |
Install a new instrument panel cushion as shown in the illustration.
| 3. INSTALL INSTRUMENT PANEL CUSHION (for TMC Made) |
![]() |
Install a new instrument panel cushion as shown in the illustration.
| 4. INSTALL INSTRUMENT PANEL CUSHION (for TMMF Made) |
![]() |
Install 2 new instrument panel cushions as shown in the illustration.
| 5. INSTALL NO. 3 INSTRUMENT PANEL CUSHION |
![]() |
Install 2 new instrument panel cushions as shown in the illustration.
| 6. INSTALL NO. 2 INSTRUMENT PANEL CUSHION |
![]() |
Install a new instrument panel cushion as shown in the illustration.
| 7. INSTALL NO. 1 INSTRUMENT PANEL CUSHION |
![]() |
Install a new instrument panel cushion as shown in the illustration.
| 8. INSTALL NO. 1 SIDE DEFROSTER NOZZLE |
![]() |
Engage the guide and the 3 claws and install the defroster nozzle.
| 9. INSTALL INSTRUMENT PANEL BOX |
![]() |
Engage the 5 claws and install a new instrument panel box.
| 10. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (for Driver Side) |
![]() |
Engage the 3 claws and install the instrument panel register.
| 11. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Engage the 4 clips and install the instrument cluster finish panel.
| 12. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Engage the 3 hooks B.
Engage the 3 hooks A to install the instrument panel passenger airbag assembly.
Install the 2 screws
| 13. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Engage the 3 guides and install the instrument panel register with the 3 <A> screws.
| 14. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY |
![]() |
Install the heater to register duct.
| 15. INSTALL NO. 2 HEATER TO REGISTER DUCT |
![]() |
Engage the 4 guides and install the heater to register duct with the 4 <A> screws.
| 16. INSTALL NO. 1 HEATER TO REGISTER DUCT |
![]() |
Engage the 4 guides and install the heater to register duct with the 4 <A> screws.