UPPER INSTRUMENT PANEL (for Hatchback) > REMOVAL |

| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE RH (for 5 Door) |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 4. REMOVE FRONT DOOR SCUFF PLATE LH (for 5 Door) |
| 5. REMOVE FRONT DOOR SCUFF PLATE RH (for 3 Door) |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 6. REMOVE FRONT DOOR SCUFF PLATE LH (for 3 Door) |
| 7. REMOVE COWL SIDE TRIM BOARD RH |
![]() |
Remove the clip.
Disengage the clip and remove the cowl side trim board.
| 8. REMOVE COWL SIDE TRIM BOARD LH |
| 9. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
Separate the front door opening trim weatherstrip.
| 10. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
Separate the front door opening trim weatherstrip.
| 11. REMOVE FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag) |
![]() |
Disengage the front pillar garnish clip and the clip.
| *1 | Front Pillar Garnish Clip |
![]() |
Using needle nose pliers, turn the front pillar garnish clip 90° and disengage it from the front pillar garnish.
| *1 | Protective Tape |
Disengage the 2 guides and remove the front pillar garnish.
for 6 speakers:
Disconnect the connector.
![]() |
Protect the curtain shield airbag assembly.
| *1 | Adhesive Tape |
| *2 | Protective Cover |
| *3 | Curtain Shield Airbag Assembly |
Cover the airbag with a cloth or piece of nylon and secure the ends of the cover with tape as shown in the illustration.
| 12. REMOVE FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag) |
| 13. REMOVE FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag) |
![]() |
Disengage the 2 clips and the 2 guides and remove the front pillar garnish.
for 6 speakers:
Disconnect the connector.
| 14. REMOVE FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag) |
| 15. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY |
![]() |
Disengage the 10 clips and the 4 guides and remove the instrument cluster finish panel garnish.
| 16. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (for Front Passenger Side) |
![]() |
Disengage the 3 claws and remove the instrument panel register.
| 17. REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY |
![]() |
Disengage the 7 clips.
Disconnect the connector and remove the instrument cluster finish center panel.
| 18. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL |
![]() |
Disengage the 5 clips and remove the instrument cluster finish panel.
| 19. REMOVE COMBINATION METER ASSEMBLY |
![]() |
Remove the 2 screws.
Disengage the 2 clips and the 2 guides.
![]() |
Disconnect the 2 connectors and remove the combination meter assembly.
| 20. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Slide the slider and disconnect the passenger airbag connector.
| *1 | Slider |
![]() |
Remove the <B> bolt.
Remove the 2 clips.

Disengage the 8 clips while lifting the rear instrument panel up.
While lifting the instrument panel, slide it toward the rear of the vehicle. Disengage the 5 guides of the front side of the instrument panel and remove the upper instrument panel.