Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › PURGE VALVE (for Hatchback)

PURGE VALVE (for Hatchback) > INSPECTION



1. INSPECT PURGE VSV


    A173833E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    26 to 30 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Purge VSV)
    If the result is not as specified, replace the No. 1 vacuum switching valve assembly.



  1. Check operation of the purge VSV.

    1. Check that air does not flow from port E to port F.

    2. Apply battery voltage across the terminals.



    3. A179486E01
    4. Check that air flows from port E to port F. If the result is not as specified, replace the purge VSV.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *a
      Component without harness connected
      (Purge VSV)