FRONT BUMPER (for Sedan) > DISASSEMBLY |
| 1. REMOVE FRONT BUMPER EMBLEM |
![]() |
Disengage the 4 claws and remove the front bumper emblem.
| 2. REMOVE RADIATOR GRILLE |
![]() |
Remove the 2 screws.
Using a screwdriver, disengage the 13 claws and remove the radiator grille.
| 3. REMOVE RADIATOR LOWER GRILLE |
![]() |
Disengage the 12 claws and remove the radiator lower grille.
| 4. REMOVE FOG LIGHT ASSEMBLY LH |
![]() |
Remove the 3 screws and the fog light assembly LH.
| 5. REMOVE FOG LIGHT ASSEMBLY RH |
| 6. REMOVE FRONT BUMPER HOLE COVER LH |
![]() |
Disengage the 4 claws and remove the front bumper hole cover LH.
| 7. REMOVE FRONT BUMPER HOLE COVER RH |
| 8. REMOVE FRONT BUMPER EXTENSION MOULDING RH |
![]() |
Disengage the 3 claws and remove the front bumper extension moulding RH.
| 9. REMOVE FRONT BUMPER SIDE RETAINER LH |
![]() |
Remove the bolt and the screw.
Disengage the 2 claws and remove the front bumper side retainer LH.
| 10. REMOVE FRONT BUMPER SIDE RETAINER RH |
| 11. REMOVE RADIATOR SUPPORT UPPER ABSORBER |
![]() |
Using a screwdriver, disengage the 6 claws and remove the radiator support upper absorber.
| 12. SEPARATE THERMISTOR ASSEMBLY (w/ Air Conditioning System) |
![]() |
Disengage the 2 clamps and remove the thermistor assembly.
| 13. REMOVE RADIATOR SIDE AIR SEAL LH |
![]() |
Disengage the 4 claws and remove the radiator side air seal LH.
| 14. REMOVE RADIATOR SIDE AIR SEAL RH |
| 15. DISCONNECT NO. 2 ENGINE ROOM WIRE |
![]() |
Using a clip remover, disengage the 7 clamps and disconnect the No. 2 engine room wire.
| 16. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
![]() |
Remove the 6 bolts, 4 nuts and the front bumper reinforcement sub-assembly.
| 17. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET |
![]() |
Remove the 2 nuts and the front bumper stone deflector bracket.
| 18. REMOVE HEADLIGHT ASSEMBLY RH |
| 19. REMOVE WINDSHIELD WASHER JAR ASSEMBLY |
![]() |
Remove the 2 bolts.
Disengage the location pin and the windshield washer jar assembly.
| 20. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY LH |
![]() |
Remove the 4 bolts.
Disengage the 2 location pins and the front bumper arm sub-assembly LH.
| 21. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY RH |