Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER (for Sedan)

FRONT BUMPER (for Sedan) > DISASSEMBLY



1. REMOVE FRONT BUMPER EMBLEM


    B134824
  1. Disengage the 4 claws and remove the front bumper emblem.



2. REMOVE RADIATOR GRILLE


    B209121
  1. Remove the 2 screws.

  1. Using a screwdriver, disengage the 13 claws and remove the radiator grille.



3. REMOVE RADIATOR LOWER GRILLE


    B134826
  1. Disengage the 12 claws and remove the radiator lower grille.



4. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)


    B134827
  1. Remove the 3 screws and the fog light assembly LH.



5. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure as for the LH side.



6. REMOVE FRONT BUMPER HOLE COVER LH


    B134829
  1. Disengage the 4 claws and remove the front bumper hole cover LH.



7. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedure as for the LH side.



8. REMOVE FRONT BUMPER EXTENSION MOULDING RH


    B134830
  1. Disengage the 3 claws and remove the front bumper extension moulding RH.



9. REMOVE FRONT BUMPER SIDE RETAINER LH


    B134807
  1. Remove the bolt and the screw.

  1. Disengage the 2 claws and remove the front bumper side retainer LH.



10. REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



11. REMOVE RADIATOR SUPPORT UPPER ABSORBER


    B138544
  1. Using a screwdriver, disengage the 6 claws and remove the radiator support upper absorber.



12. SEPARATE THERMISTOR ASSEMBLY (w/ Air Conditioning System)


    B209580
  1. Disengage the 2 clamps and remove the thermistor assembly.



13. REMOVE RADIATOR SIDE AIR SEAL LH


    B134811
  1. Disengage the 4 claws and remove the radiator side air seal LH.



14. REMOVE RADIATOR SIDE AIR SEAL RH

HINT:
Use the same procedure as for the LH side.



15. DISCONNECT NO. 2 ENGINE ROOM WIRE (w/ Fog Light)


    B209578
  1. Using a clip remover, disengage the 7 clamps and disconnect the No. 2 engine room wire.



16. DISCONNECT NO. 2 ENGINE ROOM WIRE (w/o Fog Light)


    B209579
  1. Using a clip remover, disengage the 6 clamps and disconnect the No. 2 engine room wire.



17. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B134817
  1. Remove the 6 bolts, 4 nuts and the front bumper reinforcement sub-assembly.



18. REMOVE FRONT BUMPER STONE DEFLECTOR BRACKET


    B134818
  1. Remove the 2 nuts and the front bumper stone deflector bracket.

    HINT:
    Use the same procedure for both sides.



19. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



20. REMOVE WINDSHIELD WASHER JAR ASSEMBLY
  1. Disconnect the windshield washer motor and pump assembly connector.



    B126351E02
  1. Remove the 2 bolts.

  1. Disengage the location pin and the windshield washer jar assembly.



21. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY LH


    B126350
  1. Remove the 4 bolts.

  1. Disengage the 2 location pins and the front bumper arm sub-assembly LH.



22. REMOVE FRONT BUMPER ARM SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.