FRONT BUMPER (for Sedan) > REASSEMBLY |
| 1. INSTALL FRONT BUMPER ARM SUB-ASSEMBLY LH |
![]() |
Insert the 2 location pins into the 2 body holes and install the front bumper arm sub-assembly LH with the 4 bolts.
| 2. INSTALL FRONT BUMPER ARM SUB-ASSEMBLY RH |
| 3. INSTALL WINDSHIELD WASHER JAR ASSEMBLY |
![]() |
Insert the location pin into the body hole and install the windshield washer jar assembly with the 2 bolts.
| 4. INSTALL HEADLIGHT ASSEMBLY RH |
| 5. INSTALL FRONT BUMPER STONE DEFLECTOR BRACKET |
![]() |
Install the front bumper stone deflector bracket with the 2 nuts.
| 6. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY |
![]() |
Install the front bumper reinforcement with the 6 bolts and 4 nuts.
| 7. CONNECT NO. 2 ENGINE ROOM WIRE (w/ Fog Light) |
![]() |
Engage the 7 clamps and install the No. 2 engine room wire.
| 8. CONNECT NO. 2 ENGINE ROOM WIRE (w/o Fog Light) |
![]() |
Engage the 6 clamps and install the No. 2 engine room wire.
| 9. INSTALL RADIATOR SIDE AIR SEAL LH |
![]() |
Engage the 4 claws and install the radiator side air seal LH.
| 10. INSTALL RADIATOR SIDE AIR SEAL RH |
| 11. INSTALL THERMISTOR ASSEMBLY (w/ Air Conditioning System) |
![]() |
Engage the 2 clamps and install the thermistor assembly.
| 12. INSTALL RADIATOR SUPPORT UPPER ABSORBER |
![]() |
Engage the 6 claws and install the radiator support upper absorber.
| 13. INSTALL FRONT BUMPER SIDE RETAINER LH |
![]() |
Engage the 2 claws and install the front bumper side retainer LH.
Install the screw and the bolt.
| 14. INSTALL FRONT BUMPER SIDE RETAINER RH |
| 15. INSTALL FRONT BUMPER EXTENSION MOULDING RH |
![]() |
Engage the 3 claws and install the front bumper extension moulding RH.
| 16. INSTALL FRONT BUMPER HOLE COVER LH |
![]() |
Engage the 4 claws and install the front bumper hole cover LH.
| 17. INSTALL FRONT BUMPER HOLE COVER RH |
| 18. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light) |
![]() |
Install the fog light assembly LH with the 3 screws.
| 19. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light) |
| 20. INSTALL RADIATOR LOWER GRILLE |
![]() |
Engage the 12 claws and install the radiator lower grille.
| 21. INSTALL RADIATOR GRILLE |
![]() |
Engage the 13 claws and install the radiator grille.
Install the 2 screws.
| 22. INSTALL FRONT BUMPER EMBLEM |
Engage the 4 claws and install the front bumper emblem.