Home › General › SPECIFICATIONS › 1NZ-FE ENGINE CONTROL (for Sedan)

1NZ-FE ENGINE CONTROL (for Sedan) > SERVICE DATA



Spark plug insulation standard resistance
-
10 MΩ or more
Spark plug electrode gap
For new spark plug
1.0 to 1.1 mm (0.039 to 0.043 in.)
Spark plug maximum electrode gap
For used spark plug
1.3 mm (0.051 in.)
Camshaft timing oil control valve standard resistance
1 - 2
6.9 to 7.9 Ω at 20 °C (68°F)
Throttle with motor body standard resistance
1 (M-) - 2 (M+)
0.3 to 100 Ω at 20 °C (68°F)
Accelerator pedal position No. 1 standard voltage
Accelerator pedal released
0.5 to 1.1 V
Accelerator pedal depressed
2.6 to 4.5 V
Accelerator pedal position No. 2 standard voltage
Accelerator pedal released
1.2 to 2.0 V
Accelerator pedal depressed
3.4 to 5.0 V
Camshaft position sensor standard resistance
-
1630 to 2740 Ω at cold
2065 to 3225 Ω at hot
Crankshaft position sensor standard resistance
-
985 to 1600 Ω at cold
1265 to 1890 Ω at hot
Engine coolant temperature sensor standard resistance
-
2.32 to 2.59 kΩ Approximately 20°C (68°F)
0.310 to 0.326 kΩ Approximately 80°C (176°F)
Knock sensor standard resistance
-
120 to 280 kΩ at 20 °C (68°F)
Air fuel ratio sensor standard resistance
1 (HA1A) - 2 (+B)
1.8 to 3.4 Ω at 20°C (68°F)
1 (HA1A) - 4 (A1A-)
10 kΩ or higher
Heated oxygen sensor standard resistance
1 (HT1B) - 2 (+B)
11 to 16 Ω at 20°C (68°F)
1 (HT1B) - 4 (E2)
10 kΩ or higher
EFI fuse standard resistance
1 - 2
Below 1 Ω
AM2 fuse standard resistance
1 - 2
Below 1 Ω
Integration relay (EFI relay) resistance
C1 - A1
Below 1 Ω
C1 - A4
10 kΩ or higher
(Battery voltage not applied)
C1 - A4
Below 1 Ω
(Battery voltage applied to terminals A2 and A3)
Integration relay (FAN NO. 1 relay) resistance
B5 - B8
10 kΩ or higher
(Battery voltage not applied)
B5 - B8
Below 1 Ω
(Battery voltage applied to terminals B6 and B7)
Integration relay (IG2 relay) resistance
C1 - B1
Below 1 Ω
C1 - B4
10 kΩ or higher
(Battery voltage not applied)
C1 - B4
Below 1 Ω
(Battery voltage applied to terminals B2 and B3)