Home › General › SPECIFICATIONS › 1NZ-FE ENGINE CONTROL (for Sedan)

1NZ-FE ENGINE CONTROL (for Sedan) > TORQUE SPECIFICATIONS



Part tightened
N*m
kgf*cm
ft.*lbf
Camshaft timing oil control valve assembly x Cylinder head assembly
7.5
76
66 in.*lbf
Fan belt adjusting bar x Oil pump assembly
11
112
8.1
Throttle with motor body assembly x Intake manifold
9.0
92
80 in.*lbf
Water filler sub-assembly x Throttle with motor body assembly
7.5
76
66 in.*lbf
Throttle with motor body assembly x Wire harness with bracket
9.0
92
80 in.*lbf
Air cleaner cap sub-assembly x Air cleaner hose No. 1
3.0
31
27 in.*lbf
ECM x body
8.0
82
71 in.*lbf
Cowl top panel outer x body
6.5
66
58 in.*lbf
Cowl top panel outer center bracket x body
6.5
66
58 in.*lbf
Accelerator pedal assembly x body
10
102
7.4
Camshaft position sensor x Cylinder head assembly
8.0
82
71in.*lbf
Crankshaft position sensor x Oil pump assembly
7.5
76
66 in.*lbf
Spark plug x Cylinder head assembly
18
184
13
Ignition coil x Cylinder head assembly
9.0
92
80 in.*lbf
Cylinder head cover No. 2 x Cylinder head assembly
7.0
71
62 in.*lbf
Engine coolant temperature sensor x Cylinder head assembly
20
204
15
Knock sensor x Cylinder block assembly
20
204
15
Intake manifold x Cylinder block assembly
30
304
22
Air fuel ratio sensor x Exhaust manifold
without SST
44
449
32
Air fuel ratio sensor x Exhaust manifold
with SST
40
408
30
Heated oxygen sensor x front exhaust pipe assembly
without SST
44
449
32
Heated oxygen sensor x front exhaust pipe assembly
with SST
40
408
30
Battery negative terminal x Battery negative cable
5.4
55
48 in.*lbf