Home › General › SPECIFICATIONS › 1NZ-FE FUEL (for Sedan)

1NZ-FE FUEL (for Sedan) > SERVICE DATA



Fuel pressure
Standard fuel pressure
304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)
Fuel pressure : at fuel while the engine idles
Standard fuel pressure
304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)
Fuel pressure : at fuel pressure remains for 5 minutes after engine has stopped
Standard fuel pressure
147 kPa (1.5 kgf/cm2, 21 psi) or more
Fuel injector assembly
Standard resistance
11.6 to 12.4 Ωat 20°C (68°F)
Injection volume
47 to 58 cm3(2.9 to 3.5 cu in.) per 15 seconds Connect
Difference between each injector
11 cm3(0.6 cu in.) or less
Fuel drop
1 drop or less every 12 minutes
Fuel pump
Standard resistance
0.2 to 3.0 Ω at 20°C (68°F)
Fuel sender gauge assembly
Type A
F (Upper End)
12.0 to 18.0
F (Lower End)
405.0 to 415.0
Type B
F (Upper End)
13.5 to 16.5
F (Lower End)
405.5 to 414.5