Home › General › SPECIFICATIONS › 1NZ-FE COOLING (for Sedan)

1NZ-FE COOLING (for Sedan) > SERVICE DATA



Thermostat
Valve opening temperature
80 to 84°C (176 to 183°F)
Valve lift
8.5 mm (0.335 in.) or more at 95°C (203°F)
Cooling fan No. 1 relay
3-5 (When battery voltage not applied)
10 kΩ or higher
3-5 (When battery voltage applied to terminals 1 and 2)
Below 1 Ω
Cooling fan motor
at 20°C (68°F)
7.4 to 10.9A
Cooling fan No. 2 relay
3-4 (When battery voltage not applied)
Below 1Ω
3-4(When battery voltage applied to terminals 1 and 2)
10KΩ or higher
3-5 (When battery voltage not applied)
10KΩ or higher
3-5 (When battery voltage applied to terminals 1 and 2)
Below 1Ω
Radiator cap sub-assembly
Standard valve (for brand new cap)
93.3 to 122.7 kpa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard valve (after using cap)
78.5 kpa (0.8 kgf/cm2, 11.4 psi)
Cooling fan resistor
at 20°C (68°F)
1.17 to 1.43 Ω