Home › General › SPECIFICATIONS › 1NZ-FE COOLING (for Hatchback)

1NZ-FE COOLING (for Hatchback) > SERVICE DATA



Thermostat
Valve opening temperature
80 to 84°C (176 to 183°F)
Valve lift
8.5 mm (0.335 in.) or more at 95°C (203°F)
Cooling fan motor
1(-) - 2(+)
7.4 to 10.9A at 20°C (68°F)
Water filler cap sub-assembly
Standard valve (for brand new cap)
93.3 to 122.7 kpa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard valve (after using cap)
78.5 kpa (0.8 kgf/cm2, 11.4 psi)
Cooling fan resistor
1 - 2
1.17 to 1.43 Ω at 20°C (68°F)
Fan No. 1 relay
3 - 5
10 kΩ or higher (Battery voltage not applied)
3 - 5
Below 1 Ω (Battery voltage applied to terminals 1 and 2)
Fan No. 2 relay
3 - 4
Below 1Ω (Battery voltage not applied)
3 - 4
10KΩ or higher (Battery voltage applied to terminals 1 and 2)
3 - 5
10KΩ or higher (Battery voltage not applied)
3 - 5
Below 1Ω (Battery voltage applied to terminals 1 and 2)