1NZ-FE STARTING (for Sedan) > SERVICE DATA |
| Starter assembly | Standard current | 90 A or less at 11.5 V |
| Starter relay | Standard resistance 3 - 5 | Below 1 Ω(when battery voltage applied to terminals 1 and 2) |
| 10 kΩ or higher | ||
| ACC cut relay | Standard resistance 3 - 4 | Below 1 Ω |
| 10 kΩ or higher (when battery voltage applied to terminals 1 and 2) | ||
| Standard resistance 3 - 5 | Below 1 Ω(when battery voltage applied to terminals 1 and 2) | |
| 10 kΩ or higher | ||
| Ignition or starter switch assembly. | Standard resistance Between all terminals | 10 kΩ or higher (LOCK) |
| Standard resistance 2 - 4 | Below 1 Ω (ACC) | |
| Standard resistance 1 - 2 - 4 | Below 1 Ω (ON) | |
| Standard resistance 5 - 6 | ||
| Standard resistance 1 - 3 - 4 | Below 1 Ω (START) | |
| Standard resistance 5 - 6 - 7 | ||
| Starter armature assembly resistance | Segments | Below 1 Ω |
| Commutator - Armature coil | 10kΩ or higher | |
| Starter armature assembly commutator circumference runout | Maximum runout | 0.05 mm (0.0020 in.) |
| Starter armature assembly commutator diameter | Standard diameter | 28.0 mm (1.1024 in.) |
| Minimum diameter | 27.0 mm (1.0630 in.) | |
| Starter armature assembly undercut portion | Standard undercut depth | 0.6 mm (0.0236 in.) |
| Minimum undercut depth | 0.2 mm (0.0079 in.) | |
| Starter yoke assembly resistance | Terminal C - Field coil brush lead | Below 1 Ω |
| Brush lead - starter yoke | 10 kΩ or higher | |
| Brush length | Standard length | 14 mm (0.5511 in.) |
| Minimum length | 9 mm (0.3543 in.) | |
| Starter brush holder assembly resistance | Standard resistance | 10kΩ or higher |
| Magnet starter switch assembly resistance | Terminal C - Terminal 50 | Below 1 Ω |
| Terminal 50 - Magnet starter switch assembly | Below 2 Ω |