DTC C1515/15 Torque Sensor Zero Point Adjustment is not Initialized |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1515/15 | Torque sensor zero point calibration not performed. |
|
| 1.PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR) |
| NEXT | |
| 2.CONFIRM DTC |
Check for DTCs (Click here ).
| DTC still output even after performing torque sensor zero point calibration 3 times. | A |
| DTC still output even after performing torque sensor zero point calibration once or twice. | B |
| Normal system code output. | C |
|
| ||||
|
| ||||
| A | ||
| ||