Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › CANISTER (for Hatchback)

CANISTER (for Hatchback) > INSTALLATION



1. INSTALL CHARCOAL CANISTER ASSEMBLY
  1. Install the charcoal canister assembly with the 3 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Connect the connector.



2. CONNECT FUEL EMISSION HOSE
  1. Connect the fuel emission hose to the charcoal canister with the hose clamp.



3. CONNECT NO. 2 CHARCOAL CANISTER FILTER


    A261159E01
  1. Connect the No. 2 charcoal canister filter and lock it by pushing in the retainer.
    *1
    Retainer
    *2
    Fuel tank Vent hose Connector
    *3
    O-ring
    V100135
    Push

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the charcoal canister outlet tube is inserted securely.
    3. Check that the charcoal canister outlet tube is securely connected by pulling on it.



4. CONNECT FUEL TANK VENT HOSE


    A261160E01
  1. Connect the fuel tank vent hose and lock it by pushing in the retainer.
    Text in Illustration 
    *1
    Retainer
    *2
    Fuel Tank Vent Hose Connector
    *3
    O-ring
    V100135
    Push

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the fuel tank vent hose is inserted securely.
    3. After installing the retainer, check that the fuel tank vent hose is securely connected by pulling on it.

    HINT:
    1. Insert the inlet tube until a "click" sound is heard.
    2. The quick connector cannot be locked when the tube is not inserted securely.