Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › CANISTER (for Hatchback)

CANISTER (for Hatchback) > REMOVAL



1. DISCONNECT FUEL TANK VENT HOSE


    A259869E01
  1. Release the retainer as shown in the illustration and disconnect the fuel tank vent hose.
    Text in Illustration 
    *1
    Retainer
    V100135
    Push
    V100136
    Pull

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The quick connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. Do not use any tools.
    4. Do not bend or twist the tubes.
    5. Protect the contact surface by covering it with a plastic bag.
    6. If the connector is stuck, push and pull on the parts to separate them.



2. DISCONNECT FUEL EMISSION HOSE


    A259870
  1. Loosen the hose clamp and disconnect the fuel emission hose.



3. DISCONNECT NO. 2 CHARCOAL CANISTER FILTER


    A259871E01
  1. Release the retainer as shown in the illustration and disconnect the No. 2 charcoal canister filter.
    Text in Illustration 
    *1
    Retainer
    V100135
    Push
    V100136
    Pull

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The quick connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. Do not use any tools.
    4. Do not bend or twist the tubes.
    5. Protect the contact surface by covering it with a plastic bag.
    6. If the connector is stuck, push and pull on the parts to separate them.



4. REMOVE CHARCOAL CANISTER ASSEMBLY


    A259872
  1. Disconnect the connector.



    A259873
  1. Remove the 3 bolts and the charcoal canister assembly.