Home › Vehicle Exterior › LIGHTING (EXT) › RELAY (for Hatchback)

RELAY (for Hatchback) > ON-VEHICLE INSPECTION



1. INSPECT HEADLIGHT DIMMER RELAY


    E223161
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage not applied
    Below 1 Ω
    Battery voltage applied to terminal 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage not applied
    10 kΩ or higher
    Battery voltage applied to terminal 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



2. INSPECT HEADLIGHT RELAY


    E209495
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied
    10 kΩ or higher
    Battery voltage applied to terminal 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.