Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH (for Sedan)

BACK-UP LIGHT SWITCH (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY


    C162586E01
  1. Using SST, install the back-up light switch and a new gasket to the transaxle case.

    SST
    09817-16011  

    Torque:
    40 N*m{ 410 kgf*cm , 30 ft.*lbf }



    C176531E01
  1. Install the 2 clamps.

    NOTICE:
    Be sure to use boss B.

  1. Connect the back-up light switch connector.



2. CONNECT TRANSMISSION CONTROL SHIFT CABLE


    C176533E02
  1. Connect the transmission control shift cable with the clip*1.

  1. Connect the transmission control shift cable with a new clip*2.



3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


A116972
  1. Install air cleaner cap sub-assembly with air cleaner hose No. 1.

  1. Tighten the hose clamp to the specified torque.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



    A116971
  1. Connect the wire harness clamp and mass air flow meter connector.



    A116970
  1. Connect ventilation hose No. 2.



    A133593
  1. Connect the vacuum switching valve assembly connector and wire harness clamp.

  1. Connect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 to the vacuum switching valve assembly.



4. INSTALL NO. 2 CYLINDER HEAD COVER


A116235E01
  1. Tighten the 2 A nuts, then the 2 B nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }