Home › Drivetrain ยท C50 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH (for Sedan)

BACK-UP LIGHT SWITCH (for Sedan) > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


A116235
  1. Remove the 4 nuts and cylinder head cover No. 2.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


A133593
  1. Disconnect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 from the vacuum switching valve assembly.

  1. Disconnect the vacuum switching valve assembly connector and wire harness clamp.



    A116970
  1. Disconnect ventilation hose No. 2.



    A116971
  1. Disconnect the wire harness clamp and mass air flow meter connector.



    A116972
  1. Loosen the hose clamp, unlock the air cleaner assembly clamp and remove air cleaner cap sub-assembly with air cleaner hose No. 1.



3. DISCONNECT TRANSMISSION CONTROL SHIFT CABLE


    C176533
  1. Remove the 2 clips, and disconnect the transmission control shift cable.



4. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY


    C176531
  1. Disconnect the back-up light switch connector and 2 clamps.



    C162586E01
  1. Using SST, remove the back-up light switch and gasket from the transaxle case.

    SST
    09817-16011