Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH (for Hatchback)

CRUISE CONTROL MAIN SWITCH (for Hatchback) > INSPECTION



1. INSPECT CRUISE CONTROL MAIN SWITCH



E144930E17

  1. Measure the resistance and check the results in accordance with the value(s) in the table below.

    Text in Illustration 
    *a
    Component without harness connected
    (Cruise Control Main Switch)
    *b
    Cruise Control Main Switch
    *c
    Lever
    *d
    ON/OFF
    *e
    -SET
    *f
    +RES
    *g
    CANCEL
    -
    -

    Standard resistance:

    Tester Connection
    Switch Condition
    Specified Condition
    1(ECC) - 3(CCS)
    Main Switch off*1
    1 MΩ or higher
    Main Switch on
    Below 2.5 Ω
    +RES
    235 to 245 Ω
    -SET
    617 to 643 Ω
    CANCEL
    1509 to 1571 Ω

    *1: The lever is in the neutral position.
    If the result is not as specified, replace the cruise control main switch.