Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH (for Hatchback)

CLUTCH SWITCH (for Hatchback) > INSPECTION



1. INSPECT NO. 2 CLUTCH START SWITCH ASSEMBLY


C195260E03
  1. Check the resistance between the terminals when the switch is ON and OFF.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 clutch start switch assembly)
    *b
    6.5 to 7.5 mm (0.256 to 0.295 in.)

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    OFF (released)
    10 kΩ or higher
    ON (pushed in)
    Below 1 Ω

    If the result is not as specified, replace the No. 2 clutch start switch assembly.