Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Hatchback)

SHIFT LEVER (for Hatchback) > INSTALLATION



1. INSTALL SHIFT LEVER ASSEMBLY
  1. Engage the 2 wire harness clamps and install the wire harness to the shift lever assembly.

  1. Connect the 2 connectors to the shift lever assembly.

  1. Temporarily install the shift lever assembly to the vehicle with the 4 bolts.



    C244559E01
  1. Fully tighten the 4 bolts in the order shown in the illustration.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C195134E04
  1. Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
    Text in Illustration 
    *1
    Nut
    *2
    Lock
    *a
    Rotate approximately 180°
    *b
    Push in

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



    C271865E01
  1. Install the transmission control cable assembly to the shift lever assembly.
    Text in Illustration 
    *1
    Protrusion
    *2
    Lock
    *a
    Push in

    NOTICE:
    1. Install the transmission control cable assembly with the protrusion facing upwards.
    2. After installation, make sure that the lock is projecting from A as shown in the illustration.
    3. Make sure that the transmission control cable assembly are securely locked.



    C244594
  1. Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the shift lever assembly.

    NOTICE:
    1. Securely install the end of the transmission control cable assembly to the shift lever assembly.
    2. Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.



3. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.



    C195135E01
  1. Slide the adjuster case cover in the direction shown by the arrow.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Cover
    *3
    Lock Piece

  1. Using a precision screwdriver, pull up the lock piece.



    C195136E01
  1. Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Lock Piece
    *3
    Cable Rod
    *4
    Cover

  1. Push in the lock piece of the adjuster case to lock it.

  1. Slide the adjuster case cover in the direction shown by the arrow.

    NOTICE:
    If the cover is not pushed over the protrusion on the lock, the cable will not lock and shift operation will not be accurate.



4. INSPECT SHIFT LEVER POSITION
  1. Turn the ignition switch to ON and step on the brake pedal.

  1. Confirm that the shift lever moves smoothly through all of the shift positions and the position indicator shows the correct shift lever position.

  1. Start the engine and confirm that the vehicle moves forward when the shift lever is moved from N to D.



5. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)


6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    C271863E01
  1. Turn the shift lever knob sub-assembly clockwise and install it to the shift lever assembly.
    Text in Illustration 
    *1
    Shift Lever Knob Cover

    NOTICE:
    Do not hold the shift lever knob cover when tightening the shift lever knob sub-assembly.