Home › Drivetrain ยท U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Hatchback)

SHIFT LEVER (for Hatchback) > REMOVAL



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Apply the parking brake and move the shift lever to N.



    C271861E01
  1. Turn the shift lever knob sub-assembly counterclockwise and remove it from the shift lever assembly.
    Text in Illustration 
    *1
    Shift Lever Knob Cover

    NOTICE:
    Do not hold the shift lever knob cover when loosening the shift lever knob sub-assembly.



2. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


3. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C244553
  1. Disconnect the end of the transmission control cable assembly from the shift lever assembly.



    C271864E01
  1. Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the shift lever assembly.
    Text in Illustration 
    *1
    Nut
    *a
    Rotate approximately 180°
    *b
    Pull out

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



4. REMOVE SHIFT LEVER ASSEMBLY


    C271862
  1. Disconnect the 2 connectors from the shift lever assembly.

  1. Disengage the 2 wire harness clamps and separate the wire harness from the shift lever assembly.



    C244559
  1. Remove the 4 bolts and the shift lever assembly from the vehicle.