BLACK OUT TAPE (for Hatchback Front Door) > INSTALLATION |
| 1. INSTALL NO. 1 BLACK OUT TAPE |
Application precautions.
Application temperature.
Pre-application procedure.
Handling.
Application method (method of squeegee operation and application for general portions).

![]() |
Application method (method of squeegee operation).
Application method (method of squeegee operation and application method for corner sections).
Inspection.
Clean the attachment surface (using an infrared light).
Using an infrared light, heat any black out tape and adhesive remaining on the body.
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Using a piece of cloth, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Clean the attachment surface (using a tape removal disc).
Set the 8 discs in the holder and insert the removal disc into an air drill or electric drill.
Using a tape removal disc, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Apply new black out tape to the positions shown in the illustration.

| Dimension | Measurement |
| a | 3.0 to 5.0 mm (0.118 to 0.197 in.) |
| b | 2.0 to 4.0 mm (0.079 to 0.157 in.) |
| 2. INSTALL FRONT DOOR GLASS RUN |
| 3. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |