Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Hatchback Center Pillar)

BLACK OUT TAPE (for Hatchback Center Pillar) > INSTALLATION



1. INSTALL NO. 3 BLACK OUT TAPE
  1. Application precautions .

  1. Clean the attachment surface (using an infrared light) .

  1. Clean the attachment surface (using a tape removal disc) .



  1. Apply new outer front black out tape to the positions shown in the illustration.


    B273662E01

    Standard Measurement:
    Dimension
    Measurement
    a
    2.0 to 4.0 mm (0.079 to 0.157 in.)
    b
    5.0 to 7.0 mm (0.197 to 0.276 in.)