Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Hatchback Center Pillar)

BLACK OUT TAPE (for Hatchback Center Pillar) > REMOVAL


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE NO. 3 BLACK OUT TAPE


    B273661
  1. Using an infrared light, heat the black out tape.
    Heating Temperature 
    Item
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)

    CAUTION:
    Do not burn yourself on the hot body panel or with the infrared light.

    NOTICE:
    Do not heat the vehicle body excessively.

  1. Lift the end portion with your fingernail and peel it parallel to the attachment surface.