Home › Drivetrain · U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Sedan)

SHIFT LEVER (for Sedan) > INSPECTION



1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY


    C117648E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (IG) - 8 (E)
    Ignition switch off
    11 to 14 V
    1 (IG) - 8 (E)
    Ignition switch off
    Below 1 V
    6 (ACC) - 8 (E)
    Ignition switch ON
    11 to 14 V
    6 (ACC) - 8 (E)
    Ignition switch ACC
    11 to 14 V
    6 (ACC) - 8 (E)
    Ignition switch off
    Below 1 V
    7 (STP) - 8 (E)
    Depress brake pedal
    11 to 14 V
    7 (STP) - 8 (E)
    Release brake pedal
    Below 1 V
    12 (KLS+) - 8 (E)
    Ignition switch ACC and shift lever P
    Below 1 V
    12 (KLS+) - 8 (E)
    Ignition switch ACC and shift lever except P
    7.5 to 11 V
    12 (KLS+) - 8 (E)
    Ignition switch ACC and shift lever except P (after approx. 1 second)
    6 to 9 V

    NOTICE:
    Do not disconnect the shift lock control unit assembly connector.



    C117648E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (E) - Body ground
    Always
    Below 1 Ω

    NOTICE:
    Do not disconnect the shift lock control unit assembly connector.

    If the result is not as specified, replace the shift lock control ECU sub-assembly.