Home › Drivetrain · U340E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER (for Hatchback)

SHIFT LEVER (for Hatchback) > INSPECTION



1. INSPECT SHIFT LOCK CONTROL ECU (SHIFT LOCK CONTROL UNIT ASSEMBLY)


    C266263E01
  1. Measure the voltage according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component with harness connected
    (Shift Lock Control ECU (Shift Lock Control Unit Assembly))

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (ACC) - 7 (E)
    Ignition switch ACC
    11 to 14 V
    Ignition switch off
    Below 1 V
    4 (IG) - 7 (E)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    5 (KLS+) - 7 (E)
    Ignition switch ACC and shift lever in P
    Below 1 V
    Ignition switch ACC and shift lever not in P
    11 to 14 V
    8 (STP) - 7 (E)
    Brake pedal depressed
    11 to 14 V
    Brake pedal released
    Below 1 V

    NOTICE:
    Do not disconnect the shift lock control ECU connector.

    1. If the result is not as specified and there are no problems with the wire harness, replace the shift lock control ECU (shift lock control unit assembly).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    7 (E) - Body ground
    Always
    Below 1 Ω

    NOTICE:
    Do not disconnect the shift lock control ECU connector.

    1. If the result is not as specified and there are no problems with the wire harness, replace the shift lock control ECU (shift lock control unit assembly).



2. INSPECT TRANSMISSION CONTROL SWITCH (SHIFT LOCK CONTROL UNIT ASSEMBLY)


    C197451E15
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Control Switch (Shift Lock Control Unit Assembly))

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (NSSD) - 2 (AT3)
    Shift lever in 3 or 2
    Below 1 Ω
    Shift lever not in 3 and 2
    10 kΩ or higher
    1 (NSSD) - 3 (ATD)
    Shift lever in 3 or 2
    10 kΩ or higher
    Shift lever not in 3 and 2
    Below 1 Ω

    If the result is not as specified, replace the transmission control switch (shift lock control unit assembly).