Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for Hatchback)

BRAKE MASTER CYLINDER (for Hatchback) > DISASSEMBLY



1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY


    C234469
  1. Fix the brake master cylinder in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a pin punch 5 mm and a hammer, tap out the straight pin and remove the brake master cylinder reservoir sub-assembly.

  1. Remove the 2 grommets from the master cylinder reservoir sub-assembly.



2. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY


3. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER