Home › Engine / Hybrid System › 1NZ-FE COOLING › WATER PUMP (for Hatchback)

WATER PUMP (for Hatchback) > ON-VEHICLE INSPECTION



1. REMOVE ENGINE UNDER COVER RH


2. REMOVE FAN AND GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



3. REMOVE GENERATOR ASSEMBLY


A249989E01
  1. Remove the terminal cap.

  1. Disconnect the connector and the harness clamp.

  1. Remove the nut and disconnect the wire harness from terminal B.
    Text in Illustration 
    *1
    Terminal B



    A244005E01
  1. Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.



    A247897E01
  1. Remove the bolt A, screw B and the piping clamp.



    A244006
  1. Remove the fixing bolt and the generator assembly.



4. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

HINT:
Only perform this procedure when replacement of the engine mounting insulator RH is necessary.



    A246921
  1. Remove the 3 bolts and engine mounting insulator RH.



5. REMOVE WATER PUMP PULLEY


6. INSPECT ENGINE WATER PUMP ASSEMBLY


A234269
  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the engine water pump assembly.

  1. Install the fan and generator V belt
    (Click here)