STARTER (for Hatchback Except Cold Area Specification Vehicles) > DISASSEMBLY |
| 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Using a 7 mm socket wrench, remove the 2 bolts.
![]() |
Remove the hook from the starter pinion drive lever while lifting the rear of the magnet starter switch assembly, and then remove the magnet starter switch assembly.
| *1 | Starter Pinion Drive Lever |
| *2 | Hook |
| 2. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Using a 7 mm socket wrench, remove the 3 through bolts.
Remove the starter yoke assembly.
| 3. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Remove the starter commutator end frame assembly.
![]() |
Remove the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.
| *1 | Hammer |
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Remove the starter armature assembly from the starter brush holder assembly.
| 5. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
![]() |
Remove the rubber seal from the starter drive housing assembly.
![]() |
Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.
![]() |
Disengage the 3 claws and remove the starter armature plate from the starter center bearing clutch sub-assembly.
![]() |
Remove the 3 planet gears from the starter center bearing clutch sub-assembly.