Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › TELLTALE LIGHT ASSEMBLY (for Hatchback)

TELLTALE LIGHT ASSEMBLY (for Hatchback) > INSPECTION



1. INSPECT TELLTALE LIGHT ASSEMBLY


    B286404E01
  1. Check the hazard switch function.
    Text in Illustration 
    *a
    Component without harness connected
    (Telltale Light Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance::
      Tester Connection
      Switch Condition
      Specified Condition
      4(TB) - 5(E)
      Pushed
      Below 1 Ω
      Not pushed
      10 kΩ or higher

      If the result is not as specified, replace the telltale light assembly.



    B291150E01
  1. Check that the telltale light assembly illuminates.
    Text in Illustration 
    *a
    Component without harness connected
    (Telltale Light Assembly)

    1. Apply battery voltage to the telltale light assembly and check that the telltale light assembly illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 6(DIM)
      Battery negative (-) → 5(E)
      illuminates

      If the result is not as specified, replace the telltale light assembly.



    B291151E01
  1. Check that the front passenger airbag ON indicator illuminates.
    Text in Illustration 
    *a
    Component without harness connected
    (Telltale Light Assembly)

    1. Apply battery voltage to the telltale light assembly and check that the front passenger airbag ON indicator illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 8(LAPB)
      Battery negative (-) → 2(PAON)
      illuminates

      If the result is not as specified, replace the telltale light assembly.



    B291152E01
  1. Check that the front passenger airbag OFF indicator illuminates.
    Text in Illustration 
    *a
    Component without harness connected
    (Telltale Light Assembly)

    1. Apply battery voltage to the telltale light assembly and check that the front passenger airbag OFF indicator illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 8(LAPB)
      Battery negative (-) → 3(P-AB)
      illuminates

      If the result is not as specified, replace the telltale light assembly.