Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side)

REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side) > INSTALLATION



1. INSTALL REAR SEATBACK ASSEMBLY


    B134926E01
  1. Insert the 2 hooks into the rear seatback frame hole and install the rear seatback, tightening the 2 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B134925
  1. Install the rear seatback cover with the 2 clips.

  1. Pull up the rear seatback.



    B134924
  1. Install the rear seat outer belt into the rear seat shoulder belt guide.



2. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY


    B134923
  1. Pass the rear seat inner belt through the rear seat cushion cover pad slit.

  1. Engage the 3 hooks and install the rear seat cushion cover pad.

    NOTICE:
    Make sure that the 2 rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.