Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side)

REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side) > DISASSEMBLY


CAUTION:
Wear protective gloves. Sharp surfaces on the rear seatback frame could cause injuries to your hands.



1. REMOVE REAR SEAT CUSHION COVER (for Cover Separate Type)


    B169320
  1. Remove the 39 hog rings and the rear seat cushion cover.



2. REMOVE REAR SEAT HEADREST ASSEMBLY


    B134928E01
  1. Push the lock button of the rear seat headrest support and remove the rear seat headrest.



3. REMOVE REAR SEAT SHOULDER BELT GUIDE


    B134929
  1. Remove the 2 screws and the rear seat shoulder belt guide.



4. REMOVE REAR SEATBACK LOCK RELEASE BUTTON


    B134931
  1. Remove the rear seatback lock release button.



5. REMOVE REAR SEATBACK LOCK CONTROL BEZEL


    B134932
  1. Disengage the 2 claws and remove the rear seatback lock control bezel.



6. REMOVE REAR SEAT HEADREST SUPPORT


    B134933
  1. Using a clip remover, remove the 6 clips and open the rear seatback cover.



    B134934
  1. Remove the 8 hog rings.



    B134936
  1. Disengage the 2 claws and remove the rear seat headrest support.

    HINT:
    Use the same procedure for both sides.



7. REMOVE REAR SEATBACK STOP BUTTON GROMMET


    B134938
  1. Disengage the 2 claws and remove the rear seatback stop button grommet.



8. REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY


    B134939
  1. Remove the rear seatback frame.



9. REMOVE REAR SEAT BACK COVER (for Cover Separate Type)


    B169322
  1. Remove the 6 hog rings and the rear seat back cover.



10. REMOVE REAR SEATBACK LOCK ASSEMBLY


    B134940
  1. Remove the 2 bolts and the rear seatback lock.