Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side)

REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type LH Side) > REASSEMBLY


CAUTION:
Wear protective gloves. Sharp surfaces on the rear seatback frame could cause injuries to your hands.



1. INSTALL REAR SEATBACK LOCK ASSEMBLY


    B134940
  1. Install the rear seatback lock with the 2 bolts.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }



2. INSTALL REAR SEAT BACK COVER (for Cover Separate Type)


    B169401E01
  1. Using hog ring pliers, install the rear seat back cover with 6 new hog rings.

    NOTICE:
    1. Do not soil or scratch the separate type rear seat cover.
    2. When installing hog rings, minimize wrinkles as much as possible.



3. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY


    B134939
  1. Install the rear seatback frame.



    B134935E01
  1. Using hog ring pliers, install 8 new hog rings as shown in the illustration.



    B134933
  1. Install the rear seatback cover with the 6 clips.



4. INSTALL REAR SEATBACK STOP BUTTON GROMMET


    B134938
  1. Engage the 2 claws and install the rear seatback stop button grommet.



5. INSTALL REAR SEAT HEADREST SUPPORT


B134937E01

HINT:
Use the same procedure for both sides.

  1. Align the protruding portion of the rear seat headrest support with the installation groove of the rear seatback frame.

  1. Engage the 2 claws and install the rear seat headrest support.



6. INSTALL REAR SEATBACK LOCK CONTROL BEZEL


    B134932
  1. Engage the 2 claws and install the rear seatback lock control bezel.



7. INSTALL REAR SEATBACK LOCK RELEASE BUTTON


    B134931
  1. Install the rear seatback lock release button.



8. INSTALL REAR SEAT SHOULDER BELT GUIDE


    B134930
  1. Insert the pin into the rear seatback frame hole and install the rear seat shoulder belt guide with the 2 screws.



9. INSTALL REAR SEAT HEADREST ASSEMBLY


    B134928E01
  1. Push the lock button of the rear seat headrest support and install the rear seat headrest.



10. INSTALL REAR SEAT CUSHION COVER (for Cover Separate Type)


    B169409E01
  1. Using hog ring pliers, install the rear seat cushion cover with 39 new hog rings.

    NOTICE:
    1. Do not soil or scratch the rear seat cushion cover.
    2. When installing hog rings, minimize wrinkles as far as possible.