Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type RH Side)

REAR SEAT ASSEMBLY (for Sedan 60/40 Split Seat Type RH Side) > INSTALLATION



1. INSTALL REAR SEATBACK ASSEMBLY


    B134945E01
  1. Insert the 2 hooks into the rear seatback frame hole and install the rear seatback, tightening the 2 bolts in the sequence shown in the illustration.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B134944
  1. Install the rear seatback cover with the 2 clips.

  1. Pull up the rear seatback.



    B134943
  1. Install the rear seat outer belt into the rear seat shoulder belt guide.

  1. Install the rear center seat outer belt into the rear center seat shoulder belt guide.



2. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY


    B134923
  1. Pass the rear seat inner belt through the rear seat cushion cover pad slit.

  1. Engage the 3 hooks and install the rear seat cushion cover pad.

    NOTICE:
    Make sure that the 2 rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.