Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for Sedan)

OUTER REAR VIEW MIRROR (for Sedan) > INSTALLATION



1. INSTALL OUTER MIRROR COVER


    B136243
  1. Engage the claw on the lower part of the mirror cover.

  1. Engage the claw on the upper part of the mirror cover.

  1. After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.

    NOTICE:
    If there is a gap between the cover and the mirror body, it may cause noise during driving.



2. INSTALL OUTER REAR VIEW MIRROR GLASS


    B136244
  1. Engage the 2 claws of the outer rear view mirror grass.

  1. Engage the 2 clips and install the outer rear view mirror grass.



3. INSTALL OUTER REAR VIEW MIRROR
  1. Engage the claw and install the outer rear view mirror.

  1. Install the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B136161
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly.



    B351468
  1. Engage the 8 clips and install the front door trim board sub-assembly.

  1. Install the clip.



    B136159
  1. Install the screw.



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


B349416
  1. Engage the claw and the clip, and install the front door lower frame bracket garnish.



6. INSTALL FRONT ARMREST BASE UPPER PANEL


  1. for Driver Side:

    1. Connect the connector.



    2. B136158
    3. Engage the 7 claws and 2 clips, and install the front armrest base upper panel.

    4. Install the screw.



  1. for Front Passenger Side:

    1. Connect the 2 connectors.



    2. B141925
    3. Engage the 7 claws and 2 clips, and install the front armrest base upper panel.

    4. Install the screw.