Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for Sedan)

OUTER REAR VIEW MIRROR (for Sedan) > INSTALLATION



1. INSTALL OUTER MIRROR COVER


    B136243
  1. Engage the claw on the lower part of the mirror cover.

  1. Engage the claw on the upper part of the mirror cover.

  1. After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.

    NOTICE:
    If there is a gap between the cover and the mirror body, it may cause noise during driving.



2. INSTALL OUTER REAR VIEW MIRROR GLASS


    B136244
  1. Engage the 2 claws of the outer rear view mirror grass.

  1. Engage the 2 clips and install the outer rear view mirror grass.



3. INSTALL OUTER REAR VIEW MIRROR


B136162E01
  1. Engage the claw and install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power mirror:
    Connect the connector.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B136161
  1. w/ Power window:

    1. Connect the front door lock remote control cable and front door inside locking cable.



    2. B136160
    3. Engage the 9 clips and install the front door trim board.



    4. B136159
    5. Install the screw.



  1. w/o Power window:



      B136194
    1. Connect the front door lock remote control cable and front door inside locking cable.



    2. B136192
    3. Engage the 9 clips and install the front door trim board.



    4. B136193
    5. Tighten the screw.



5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


B136157E01
  1. Engage the claw and clip and install the front door lower frame bracket garnish.



6. INSTALL FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Install the screw.



    B141925
  1. for Front passenger side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Install the screw.



    B141926
  1. w/o Power window:

    1. Engage the 5 clips and 2 clips and install the front armrest base upper panel.

    2. Install the screw.



7. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


B136196E01
  1. Install the window regulator handle plate.

  1. Open all the windows.



    B129030E01
  1. Install the front door window regulator handle with the clip at the angle shown in the illustration.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }