Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for Sedan)

OUTER REAR VIEW MIRROR (for Sedan) > INSPECTION



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


B116953E03
  1. Check the operation.
    Text in Illustration 
    *a
    Component without harness connected
    (Outer Rear View Mirror Assembly LH)

    1. Apply battery voltage and check the operation of the outer rear view mirror assembly LH.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 5 (MV)
      Battery negative (-) → Terminal 4 (COM)
      Turns upward
      Battery positive (+) → Terminal 4 (COM)
      Battery negative (-) → Terminal 5 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MH)
      Battery negative (-) → Terminal 4 (COM)
      Turns left
      Battery positive (+) → Terminal 4 (COM)
      Battery negative (-) → Terminal 3 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror assembly LH.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


B116954E02
  1. Check the operation.
    Text in Illustration 
    *a
    Component without harness connected
    (Outer Rear View Mirror Assembly RH)

    1. Apply battery voltage and check the operation of the outer rear view mirror assembly RH.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 5 (MV)
      Battery negative (-) → Terminal 4 (COM)
      Turns upward
      Battery positive (+) → Terminal 4 (COM)
      Battery negative (-) → Terminal 5 (MV)
      Turns downward
      Battery positive (+) → Terminal 3 (MH)
      Battery negative (-) → Terminal 4 (COM)
      Turns left
      Battery positive (+) → Terminal 4 (COM)
      Battery negative (-) → Terminal 3 (MH)
      Turns right

      If the result is not as specified, replace the outer rear view mirror assembly RH.