Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for Sedan)

OUTER REAR VIEW MIRROR (for Sedan) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT ARMREST BASE UPPER PANEL


B136158
  1. for Driver Side:

    1. Remove the screw.

    2. Disengage the 2 clips and the 7 claws.

    3. Disconnect the connector and remove the front armrest base upper panel.



    B141925
  1. for Front Passenger Side:

    1. Remove the screw.

    2. Disengage the 2 clips and the 7 claws.

    3. Disconnect the 2 connectors and remove the front armrest base upper panel.



2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


B349416
  1. Disengage the clip and the claw, and remove the front door lower frame bracket garnish.



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B136159
  1. Remove the screw.



    B351468
  1. Remove the clip.

  1. Disengage the 8 clips.



    B136161
  1. Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly, and remove the front door trim board sub-assembly.



4. REMOVE OUTER REAR VIEW MIRROR


B348847
  1. Disconnect the connector.

  1. Remove the 3 nuts.

  1. Disengage the claw and remove the outer rear view mirror.



5. REMOVE OUTER REAR VIEW MIRROR GLASS


B136241E02
Text in Illustration 
*1
Moulding Remover
*2
Protective Tape
  1. Apply protective tape to the lower part of the mirror body.

  1. Press down the upper part of the mirror and tilt the mirror.

  1. Insert a moulding remover into the 2 clip installation positions on the lower part of the mirror to disengage the 2 clips.

  1. Remove the outer rear view mirror glass by pulling it downward.



6. REMOVE OUTER MIRROR COVER


    B136242
  1. Disengage the 4 claws from the inside of the mirror body.

  1. Push the upper part of the mirror cover forward to tilt it, and then disengage the claw on the lower part to remove the outer mirror cover.