FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 4. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 5. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 6. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Remove the front door opening trim weatherstrip.
| 8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Disengage the 3 claws to remove the lap belt outer anchor cover.
![]() |
Remove the bolt and disconnect the floor anchor part of the front seat outer belt assembly.
| 9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY |
![]() |
Disengage the 8 clips and 10 claws.
Disengage the 3 guides and remove the quarter trim panel.
| 10. REMOVE CENTER PILLAR UPPER GARNISH |
![]() |
Remove the 2 screws and disengage the clip.
Pass the front seat outer belt through the slit in the center pillar upper garnish and remove the center pillar upper garnish.
| 11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and the shoulder anchor.
![]() |
Using a screwdriver with its tip wrapped in protective tape, release the locking button.
Disconnect the pretensioner connector.
| *1 | Protective Tape |
| *2 | Locking Button |
![]() |
Remove the 2 bolts.
Disengage the 2 hooks and remove the front seat outer belt assembly.